Common Disadvantages And Maintenance Methods Of Labeling Machines

This or that problem will occur after the machine is used for a long time, and the label machine will be the same. The following is the common disadvantages of the labeling machine and the maintenance method of automatic labeling machine: sometimes the distance between the paper block claws and the paper passenger belt is too small, the glue is too dry, and the outer edge of the two slices of the bidding claws is not cut. Parallel, this will constitute a label stuck on the target claw, so that a few water can be mixed and the glue will be thinner or replaced with the label claws.

Sometimes the bottle and the label are not matched with the attached to the attachment, and the amount of glue is too large. Methods to adjust to make it normal.

Sometimes the glue surface on the label is too smooth, the hardness of the label is too strong, the label left and right paws, the upper and lower paws do not have the right automatic labeling machine rod groove, the viscosity of the glue is indispensable, which will constitute the label cannot be pasted by the fan -shaped rod. The method of cleaning is to use glue with a large viscosity; replace the label material, the surface of the glue surface is rough; the replacement texture with thin texture, or wrap the label for about five minutes with a wet woolen scarf before using it to soften the label; adjust the adjustment; adjust; adjust Tag device.
The rubber plate and rubber roller cannot appear in the entire length. If there is a space, you can adjust the pain bolt to adjust the rubber plate.

Adjust the rubber roller and the benchmark. There is only contact with each other without any pressure. The open space is too large, and too much glue is on the benchmark, which constitutes a glue. The open space is too small and the contact is too tight, and the glue will be squeezed away. There is no glue in the half side of the benchmark.
When there is no label, when the label can be pressed to the front end of the label box and when the label is installed, the label near the tag hook cannot be crushed.
Based on the bottle of the star wheel, when the bottle is located in the middle of the groove of the bottle wheel, the full -automatic label screw rod is adjusted to make the spiral rod enter the bottle side by the bottle but does not displace it.