How To Solve The Problem Of Round Bottle Labeling Machine

Any equipment has a failure, but some of the fault can be removed and resolved.In particular, the round bottle labeling machine, with a fault alarm system, failure will be the first time to remind the manufacturer to solve the problem.Combined with counting function, protection parameters can be self - check the problem, as long as the problem is not too serious.So what should be done when there is a problem with the labeling equipment?

1. Missing labels

The most common problem of the round bottle labeling machine is missing the label, which is not very serious, but definitely affects the factory operation.If such problems are found, they should be solved as soon as possible. It may be caused by the insufficient sensitivity of the object's electric eye during the labeling, that is, when the bottle comes over, the labeling position cannot be predicted in time.Appropriate adjustment of the appropriate sensitivity of the electrical eye, labeling speed is appropriate to solve the problem.If it is still not completely solved, then it can only indicate that there is a problem with the conveyor belt, which can be adjusted.

2. No labels

Equipment does not label, the problem is serious, may be caused by many problems.First should check the equipment system, the system is no fault to see the test object electrical eye.The electric eye is in the wrong position, and the bottle cannot be detected, so it will not be labeled naturally.If it is in the right position, you can replace it.If it's not an eye problem, it's a header problem.

3. You can't put a label on it

There are many reasons why equipment cannot be labeled, which need to be checked one by one.The speed of marking, the length of the reserved marking, the distance of the electric eye of the measured object, and the stickiness of the label may all lead to the failure to stick the label.

4. Crumpled labels

The label is wrinkled and needs to be fixed immediately.It is better to start from the length of the reserved mark of the equipment. The speed of sending the mark should not be too fast, and the length of the reserved mark should be shortened, which will naturally solve the corresponding problem.

The above labels almost never appear at the same time, but as long as there is a problem, the equipment power should be turned off and adjusted in time, so as to recover the loss of the factory.Round bottle labeling machine label problems mainly have the above several, can be adjusted to solve.