Trouble Shooting Of Labeling Machine Equipment
Jul 13, 2020
Trouble shooting of labeling machine equipment
What should we do when something goes wrong with the automatic labeling machine? Here for you to introduce: labeling machine equipment
The failure of labeling machine, many times are caused by improper human operation, part of the aging parts, summed up can be divided into the following points:
1. Inaccurate labeling;
The inaccuracy of labeling can be summarized in two aspects. First, the orientation of fixing labeling violates the practice of labeling orientation. The reasons are as follows: screws fixing the orientation become loose and shift. The label used does not meet the requirements of the labeling machine. The other is the deviation of the orientation of the labeling head, which results in the inaccuracy of embedding during labeling.
2. Continuous labeling machine labeling, or no labeling;
The reasons are as follows: parameter setting is wrong. In the same cycle, two cycles of labeling are set, resulting in the duplication of labeling. The reason for the condition of not labeling is that there is not enough lubricating oil for the labeling head, which results in great conflict during the operation of the equipment and makes the labeling stuck. Or for parts aging, should immediately replace aging parts, to avoid a series of chain reactions.
3. During the operation of the labeling machine, it suddenly stops or breaks off;
This problem is relatively serious, you should immediately check whether the parameters are wrong, or the power line short circuit, internal parts appear problems, if the parameters are wrong, you can according to the user manual debugging, if the latter two conditions, please urgently carry out after-sales service.
Special labeling machine equipment encountered small problems, self-treatment, understand the operating principle of the equipment, master the basic detection and repair skills, useful to save repair time.
