How to deal with the markup of the labeling machine?

During the debugging process of the label machine, there will be a disconnection of the subject. The reason is that there are many aspects. The following points are the reasons and processing methods of the disconnection between the labeling machine.

1. The problem of the label itself

The tabbed paper cut injury is one of the causes of the marking. One of the obvious phenomena of this problem is that the fracture is very neat. You can find that the bottom paper of the label has obvious traces of cutting injuries. As shown in the figure below, this situation is in this case. In this case, this situation is. It is because the label is too heavy for the knife.

The incorrect material of the labeling paper will also cause labels. The standard label labels are Grassin. The relative copper paper bottom paper returns the strength of the bottom paper.

2. The problem of peeling board

In addition to the problem of the label itself, the main reason for the label is also concentrated on the bidding board. One of the most important reasons is that the bidding board is too sharp. It is caused by the large amount of cutting and milling. The main treatment method is to polish the knife mouth by hand, so that the transition at the mouth of the knife is smooth. Then there is another marking caused by the knife mouth. The knife mouth is not horizontal, which causes the label to cut off the label unevenly when passing through the knife mouth, which will also cause the labeling

3. The problem of tight institutions

In the entire bidding part, the purpose of the tight institution is to ensure that the label can be separated from the bidding board relatively uniform and stable during the traction movement. When the intensity is too large, the label will also be broken. By reducing the strength of the pressure -stunned film, the elasticity of the brake rod can be solved.