Precautions for cleaning stickers

1. Don't underestimate the brushing of the sticker. It is not simply brushing and washing it. There are many precautions that need to be paid attention to. For example, you cannot use high -pressure and hot water jet devices to clean the labeling machine; keep electrical and electronic components in a dry state; you cannot use high -alkali and high -acid cleaning agents cleaning equipment; when cleaning equipment, the temperature of the water is generally 30 ~ 40 ℃ Essence

2. In addition, such as turning Yi, Zhuanyi sponge, turning fingers, pads, benchmarks and standard plate clamps, rubber rollers, scrapers, box, etc. can be brushed with wet cloth, and the surface of the device can be

Washing with a wet cloth, you can also use brush, dry cloth, etc. There are many places to pay attention to these parts when cleaning, such as when cleaning the benchmarking board and the clamping cover, put the benchmarking board together with the benchmark shaft

Wash in the warm tank, clean it after cleaning, and dry it with compressed air if necessary. Put a little lubricant when installation at the axis of the benchmark, so that you can install and disassemble. It should be noted that the benchmark

Must be placed upright or parallel.

3. For another example, when the surface of the device is cleaned, use a brush to sweep the broken glass and broken benchmarks on the surface of the device. Wipe the glue thrown on the table with a wet cloth. Wipe the protective cover with a dry cloth.

What the operator needs to pay attention to is not to use sharp equipment to clear the residual glue. You can put the drums on the drum every day and add lubricating oil. Remember to clean the mouth before refueling. Only right

The device is cleaned up to extend the service life of the equipment, thereby making better operation.