A Few Tips On Debugging Self-adhesive Labelling Machines

Self-adhesive labelling machines can be used for the labelling of a wide range of products such as labels, cartons, file folders, cardboard, books and so on. At present, the market is a more common sticker labeling machine, because of its own unique characteristics basically half of the enterprises are using it to labeling work, is now an integral part of the production of enterprises. Therefore, in order to facilitate you in the use of self-adhesive labeling machine more handy, the following I give you some of the self-adhesive labeling machine on the debugging of several small tricks, I hope that can help you.

1. Adjustment of the labelling cassette of the labelling machine.

Standard tape centerline, the centre axis of the labeling station should be squarely tangent to the cut paper. Marking of the standard paper cartridge and in the tire ring on both sides of the gap should be between 0.8 mm - 1 mm, too much to cause the standard paper cartridge marker shift appear gap oblique standard, the gap is too small will lead to poor push standard. Grab hook standard box marker position adjustment: vertical, horizontal holding marker hook in the same vertical plane, and uniformly difficult to mark paper may be captured successfully marked. Adjustment of label feed rollers: In the absence of a label, the label can be pressed into the platen of the cassette, and if the label cannot be shredded with the front of the label, the latching device is in the vicinity of the label.

2. Adjustment of the labelling machine pressure brush device.

The centre of the brush is aligned with the front label and is symmetrical on both sides. The mark is perpendicular to the surface of the container. The overlap gap of the entire container pressure brush is:10mm~15mm for single pressure brush and 5mm~10mm for combined pressure brush. the distance between the cleaning brush and the sponge is 1mm~2mm. When the bottle is not available, the cap should be 20 mm lower than when it is available. 

3. Adjustment of bottle inlet star wheel, bottle outlet star wheel and bottle inlet screw for labelling machine.

When adjusting the star wheel and screw for bottle inlet and outlet, use the bottle cap of the standard machine as the standard. First, adjust the star wheel into the bottle. When the cap is just above the bottle, adjust the starwheel so that the bottle is in the middle of the starwheel slot. Adjust the screw into the bottle:According to the star wheel into the bottle, when the bottle is located in the middle of the star wheel groove into the bottle, adjust the screw into the bottle side near the bottle without displacement. Adjusting the star wheel: when the bottle's head is just lifted, adjust the star wheel so that the bottle is in the middle of the star wheel groove.