Analysis Of The Cause Of Automatic Labeling Displacement

Causes:

1.Turn the drum fingers that are not parallel up and down.

2. The bidding board and the fingers are not adjusted in an uneven division.

3. The two fingers are inconsistent.

4. Water on the container.

5. Time to finger loose labels prematurely or too late.

6. The box installation is stored in the tilt phenomenon.

7. The box is not adjusted in place, and the springs are too large or too small, resulting in non -smooth or too loosening screw adjustment screws.

Solution:

1. Adjust the parallel of the finger seat.

2. The adjustment of the fingerprint seat is not equal to the equal division.

3. Adjust the synchronization point of the two fingers.

4. Add water to the water on the container.

5. Adjust the position of the cam.

6. Flat the box of the box. The gap between the control bar and the benchmark of the header of the box is 0.3-0.5mm.

7. In place the pull box, guide bar, and adjustment of the screws on the box.

This is the cause and solution of the body label.There are also cases where the ring label is skewed left and right and the whole is skewed in one direction. We will analyze it next time.