Reasons And Solutions For Labeling Machine Not Out Of The Target

1. First detect the electric eye of the object, it may not feel the object passing by, so there is no label. It is necessary to set the value of the electric eye of the object again, or the electric eye of the object is damaged, and it needs to be replaced;

2. Test whether the traction mechanism is tightened, if not, tighten the traction mechanism;

3. Detect whether the traction motor of the labeling machine is wired loose, broken or does not work;

4. The synchronization belt that can drive is broken, and it should be replaced;

5. There may be no signal detected on the return magnetic switch of the overmarked cylinder. Readjust the position of the magnetic switch or change it.

6. If the label switch is pressed down, it should be disconnected;

7, test whether to open the traction, only open the label to walk, to mark. The speed value is set to 0;

8, or the label itself is the problem, the label is too thin, irregular to peel off;

9. The stripping plate of the automatic labeling machine is not sharp enough to peel off the label.