Solve the problem of flat labeling machine warping

1.To increase the viscosity of the label and try to make the label stick firmly, the following aspects can be considered:

    a. Control the labeling pressure of the label during the entire labeling process of the plane labeling machine.

    b. Control the ambient temperature during the whole labeling process of the plane labeling machine: Raising the labeling ambient temperature will improve the expected effect of labeling, because with the increase of temperature, the charm of the chemical substances in the internal structure of the item will also increase, and the labeling will be easier to match. Body fusion.

    c. Improve the surface quality of the plastic tube to be attached: most of the products have varnish on the surface, which will also increase the difficulty of labeling the bottom, leakage of the contents, and micro-holes in the thickness, which will also cause the label to lift. .

2.Change the appearance of the label: make the bottom end of the label into an arc shape, and try to open the tail deformation area as much as possible. Of course, the arc can not be opened too deep, otherwise, it is very easy to cause wrinkles due to the problem of the logo itself.

3.Hazards of static eliminator: The whole process of labeling is very easy to cause tip discharge, which will harm the expected effect of labeling. Properly increasing the relative humidity of the air at the labeling site will improve to some extent. The use of ion fans is an effective solution. . The internal structure of the flat labeling machine is equipped with an air relative humidity control system, and the internal clean room level of the system can be automatically controlled independently, so that the flat labeling machine can label labels to avoid dust and improve the labeling quality of new products. There is no longer a warped label in the labeling process to achieve visual impact.